Brief Description: Trim Lower Cowl for Nose Gear Leg
Next I marked and trimmed the lower cowl for the nose gear leg.
I also read an article in the RVAtor about trimming the flanges that fit around the spinner bulkhead at a 45 degree angle on each side to greatly ease the installation and removal of the lower cowl. Anything to make life easier!
Once all of the cutting was done I lightly sanded all of the edges so I wouldn't get cut sometime down the road on the sharp fiberglass.
Lower cowl trimmed for nose gear leg
Lower cowl trimmed per a tip in the RVAtor to ease installation & removal around the spinner bulkhead
