Brief Description: Wired the twisted bundle to the pitch servo.
Today I wired the twisted bundle to the AP pitch servo. The power and ground connections were made at the Servos Power switch on the middle top panel and on the FW ground Forest-of-Tabs. I used knife splices to connect the servo wires to the bundle thinking that I may have to disconnect sometime for mx or repair. I covered the knife splices with heat shrink and grouped the connections to a stickon mount and tie wrapped them to the floor. I spiral wrapped the wires before zip tying them. The bundle will later be spiral wrapped and secured to the tunnel wall.
The pitch servo wired to the wire bundle and zip tied to stickon mount.
