KitLog pro

Powered By Kitlog Pro v2.0

Home of the Spodplane
' style=
Date:  8-14-2014
Number of Hours:  1.00
Manual Reference:  
Brief Description:  Cleaning up some bits

An eventful interval. Sorry if this is a blog rather than a log. Quick week in Singapore with Viki, she went on to visit friends in Spain, I came home and:

1). Refinished the kitchen floor. Big job, took another week and made a fearful mess that occupied the next week remediating. Already the biggest break so far in the build.

2). Lost my medical. I have a heart problem and can't do air traffic control and can't fly. Not sure yet if it is an easy process to get the medical back. Not keen to buy any more materials until I have some idea about that. Not much motivation to build. Have decided for the moment to continue with materials held and assess the next step when I run out. An embuggeration.

Found I had lost my rhythm and made some mistakes when I got going again.

Today finished trimming the final Chapter 07 reinforcements around the rear bulkheads. Sanded off the dickey wraparound bubble at the firewall on the 2 x BID I had previously forgotten. Applied a 2" tape over the site.

Trimmed seatback map pocket. Noted the slot above the heat duct probably needs taping as well. Next time I have micro.

Time Lapse movie of Chapter 07 here!

https://www.facebook.com/spodman/videos/vb.689886449/10152651009041450
' style=

Trim, trim

Trim, trim

' style=

Taping the bubble site

Taping the bubble site

' style=

Trimming map pocket

Trimming map pocket

' style=










Copyright © 2001-2021 Matronics. All Rights Reserved.