Whew! After letting the primer cure, it was time to complete the horizontal stablizer. This was my first experience with a leading edge, I had to use the tightening belts, it was tough enough that I have a little trepidation about the wings... One rivet at a time builds the plane. Some confusion in the manual again drove me to call Valter, I couldn't make out where to drill the hole in the stabilzer skin to run the wire for the electric trim, but a quick 5 minute call and I was back on track.
Before retiring for the night, I found and layed out all the parts for the elevator and pitch trim... until then...
