|
|
|
|
Marks Web Site
|
Date: 10-13-2022
|
Number of Hours: 6.00
|
Manual Reference: 10-8
|
Brief Description: Take it all apart, peel, deburr and back together
|
|
Well, it came time to add in the rudder stop skin braces and I figured the blue film may start to impact the hole locations. So, I decided it was time to take it all apart and remove the blue film and finished deburring all the edges. This took a few days, plus over the weekend I flew the RV-12 up to Mackinac Island to see the colors. The colors were nice, but it was crazy windy...especially landing on the island. Anyway, by Wednesday I managed to get it all back together and complete the rudder stop hardware. This first gotcha was not paying attention as to which side was the length measurement. I cut it to the 4-1/8”, then trimmed the angles, but this made the brace too short. I made another one the right length, but I’m guessing I’ll need to order some new angle material. For now there was enough to make another part.
|
|
Emp reassembled after removal of blue film and deburring all the edges (22-268)
|
|
Rudder Stop Brace instructions (22-269)
|
|
New part mfg and attached (22-270)
|
|
|
|
|
|
|
|
|
Copyright © 2001-2024 Matronics. All Rights Reserved. |