I did some more riveting with Pauline. We finished the upper spar to skin line and did about half of the lower edge rivets - but I think that was a mistake. I think access will be better when the wing is off the stand and in the cradle (which I have yet to build). I wasn’t paying close attention to the required rivet sizes so some are too short and will need to be drilled out. I did five of these but the access was a pain lying on the floor so the rest will have to wait for the cradle. I used the squeezer to install the rivets on the most inboard rib. The plans call for 4.5 length flush rivets, but after putting one in I used 5s, the 4.5s are too short.
