Riveted left and right landing light ribs to the outboard right wing skin. Stripped ends of landing light wires and crimped on female Molex pins. Snapped the Molex pins onn the ends of the pulse power wire and landing light power wire into the male Molex connector housing on the send of the landing light ground wire. Crimped on male Molex pins to the end of each of the five wire coming from the back of the landing light unit. Snapped each of the Molex pins on the ends of the wires coming from the landing light unit into the female Molex connector housing as directed (two of the wres coming from the landing light unit are not used, and have no associated wires in the male half of the Molex connector housing.) Connected the male and female Molex connector housings for the landing light. Installed the landing light unit onto the landing light ribs as directed. Installed landing light in the landing light cutout and screwed it in place as directed.
