Brief Description: Riveting bulkhead support plates
Forget every terrible thing that I said about my new pneumatic riveter! What a sweetie. I ignored the bad instructions in the manual, put a little air tool oil into the bottom of the air cylinder (i.e. becomes the bottom when it is turned over for adding the oil) and other than a few ejections of oil at first on the hangar floor she worked real fine. So I finally got the two Bulkhead Upright Support Plates riveted to the Bulkhead Upgright Angles, Section 1 step 14, and banished my fear of not finishing this project due to rivet incompetence.