Brief Description: Page 16-02 finished. page 16-03 and 18-04
We finally got the stall warning assembly on place and minimized travel completing step 7 of page 16-02. The 90 degrees still need to get checked, we’ll call Van’s tomorrow. Step 1 of page 16-03 is still pending. On page 16-03 we completed steps 2 through 6. On page 16-04, step 1 could not be completed because we are missing one washer, we’ll also check with Van’s if we can use any other for this purpose. Steps 2 and 3 were basically completed because we did fabricate the cables mentioned, but the Connectors are still pending because of the washer. We had to skip again to complete our left flaperon to page 18-03 where we completed step 5 (and the page) for our new skin, page 18-04 was completed because we finally deburred our A-1201C-L skin (of step 8 of said page). The skin was shipped with a small dent, so we’ll fix it and continue on page 18-05 tomorrow. On another matter, step 6 of page 40-03 was finally completed because Franklin created a #27 dimple die by drilling #27 on two metal pieces, countersinking #27 said pieces, and using the screw that goes in there as the male die.
