|
|
GA Aerospace’s Web Site
|
Date: 2-28-2018
|
Number of Hours: 14.00
|
Manual Reference:
|
Brief Description: Bucking Bar Process
|
|
Team: Alvaro Lopez, Eduardo Duran, Luis Isiordia, Angel Rodriguez, Andrea Limon, Magdalena Rios, Alma Elguezabal
Abscent:0
Today the team avanced with the riveting process using the bucking bar process, we used a masking to avoid damage and scratch the skin, all parts were clamped with clecos, for each rivet placed, we remove a cleco. we used the pneumatic hammer to this process, placed rivets #3.5 and a rivet #4 for a flange that assembled skin, rib and crossbar.
We continue to making buckingbar on skin CP2 and CP1 with rivet 3-3.5 flat, but the skin are bending by the force of the gun. we put an orange adeshiva ribbononthe skin for avoid to damaging the surface but is not enough, the force is too much and the skin is bend and marked.
After we using the riveter for place rivet in places where the buckingbar do not enter
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Copyright © 2001-2024 Matronics. All Rights Reserved.
|
