I ordered my tail number graphics, and after they came I compared them to the crap of the EAA kit sticker that I already installed. Frankly, it made me sick, so I ordered all new matching stickers. I think you will agree that this new sticker is MUCH better.
To install, I measured to the center of the headboard, and to the middle of the sticker. I traced the curve of the top of the headboard (it’s not a mirror of each side because it’s custom cut to match the fit of the bubble), then cut out the shape and taped it to where I wanted the experimental placard. I then cut the letters out and placed them spaced as they were horizontally, but on the specific arch of the headboard.
I was careful to make sure that the seats won’t block the letters.