Disassembled the front seat assembly and deburred all of the parts. Scuffed up the to large vertical structural angles in prepartion for primer. Primered the angles and set them to dry.
(Separate entry for interior finish. I wrapped all parts)
Re-cleco all of the parts back together. I had to clear each hole again with a drill due to the vinyl wrap. Squeeze riveted all of the parts. Vertical angles to seat back. Upper and lower angle with hinge assembly to the top and bottom of the seat back.
Overall very nice finish. Looking foreward to the interior upholstery
Front seatback sitting in place on upright fuselage