Powered By Kitlog Pro v2.0
Steven's RV-9A
RV-9A
Fuselage
12-24-2016
< Previous Log Entry
Next Log Entry >
Date:
12-24-2016
Number of Hours:
3.00
Manual Reference:
canopy
Brief Description:
Puzzled by canopy instructions
I tried to figure out where to start trimming the canopy.
The instructions were not entirely clear.
There are mold marks that I think are supposed to be removed, but I am not sure of where to make the cuts, and this is an $1,100 piece of plastic!!!!
I am going to wait until monday and call van's.
I did a couple of additional steps that I did not take pictures of.
I used my laser to locate the long axis center-line of the canopy.
I test fitted the canopy frame and found the best location for the frame to lay in.
I then located the latch hole - which is critical for overall canopy allignment.
Didn't get much work done overall - sort of stalled re: where to cut.
Where to cut?
Where to cut
centerline and drilled latch
< Previous Log Entry
Next Log Entry >
SITE NAVIGATION
Contact Builder
RV-9A Home
Category
# Logs
# Hours
All
200
1014
Avionics
12
54
Empennage
2
16
Engine
22
116
Fuselage
86
367
Miscellaneous
62
356
None
1
12
Shop Supplies
2
20
Wings
13
73
Copyright © 2001-2024 Matronics. All Rights Reserved.