KitLog pro

Powered By Kitlog Pro v2.0

Bob's RV-8 Build Site
' style=
Date:  6-28-2020
Number of Hours:  2.40
Manual Reference:  
Brief Description:  Electrical component mounting panel #2

A friend Rob has a box break in his hangar that I have access to. I went down early around 0630 one morning and used it to make the bends in the the electrical mounting panel. I never used a box break but it wasn't that hard to figure out. I made the bends and finished up in a little over an hour.

When I brought the panel back I checked it for fit and made just some minor adjustments to it. Then I took some time to start figuring out where I am going to mount everything. I played with a couple configurations but haven't locked down where I am going to place everything yet. I will continue next session and starting mounting the components.
' style=

Mpunting panel bends made

Mpunting panel bends made

' style=

Configuration 1

Configuration 1

' style=

Configuration 2

Configuration 2

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.