Brief Description: Run Glide Switch ground and D-sub, Seats
I ran the Discrete IN 2 wire last session so tonight I wanted to run the ground to the forrest of tabs to complete the ground circuit. After getting the wire in place I made a couple labels and laced and wire tied both wires to the supports along the routing.
Next I re-assembled the D-sub connector for the AOA module. Last session when Ralph was here we took it apart to make sure the pins and wiring were correct....I just hadn't gotten to put it back together yet so I did that as well.
Also added some time for working on a seat order. I was in contact with several seat providers and upholesterers and was trying to get my head wrapped around what I was going to do. At the same time my buddy Jim was also looking. Well Jim had an old 15% off card that he received years ago and parlayed that into a group(of two} discount.....so that sealed the deal and we worked back and forth on locking down the details for a while in the afternoon so I included some of that time in this log.......many thanks to "Jimmy the Seat"!