Ralph contacted me on Saturday about a couple of things and during the conversation he said his wife was going to go to some function on Sunday so he could come over for a session of help. He said he wants to see the airplane fly while both of us are still sanding upright! haha
So Ralph showed up and after the complimentary bacon, eggs, sausage and toast breakfast I provide for him....we headed down the airplane skunkworks in the basement.
Ralph got started on putting the new connector on the elevator trim motor. I was working on the flap motor and position sensor. I broke off of that to get the run ready for the trim power. I had bought some 22-3 sheilded cable for the run that ended up needing to be spliced due to being too short to reach the trim motor. After that it was Ralph working on various items and myself working on others. We put in a full day and more progress made but not as evident.
I would help ralph while running wires and other avionics stuff and then would work by myself if not needed by him. We traced a few wires to be sure of their origion and destination.
