KitLog pro

Powered By Kitlog Pro v2.0

Steve & Nancy Riffe
' style=
Date:  3-9-2013
Number of Hours:  0.50
Manual Reference:  
Brief Description:  Install Roll Bar-Final (I hope)

I installed the roll bar-I think this should be the final time, so I torqued all fasteners—then applied torque seal. Next, I installed the seat floors, rear baggage floor and seats—mostly to clear up some room in the shop. I cleaned up the shop and put up the tools that have been laying out for quite some time. I was planning to retrieve the canopy from my Mother’s garage (just down the street), but the wind was blowing over 35—did not want to take a chance on the canopy flying without the rest of the airplane attached to it—maybe I can retrieve it tomorrow.
' style=

Install roll bar and interior stuff

Install roll bar and interior stuff

' style=

Nuts torqued and sealed

Nuts torqued and sealed

' style=










Copyright © 2001-2019 Matronics. All Rights Reserved.