KitLog pro

Powered By Kitlog Pro v2.0

Steve & Nancy Riffe
' style=
Date:  2-26-2016
Number of Hours:  1.00
Manual Reference:  
Brief Description:  Cowling nose work-4

Post 1. I was going to wait to mix up some resin when I had other glass work, but I need to get the nose finished so I can separate the halves—working on baffles and need to temp install cowl. So, I built some “dams” from modeling clay to keep the resin/flox where I need to fill some low spots on a slanted area. I applied the mixture in these low areas—after the goop sets up, I’ll cut away the clay and sand the nose—again.
' style=

Clay

Clay "Dam" to hold resin in place

' style=

Opposite side clay

Opposite side clay "dam"

' style=










Copyright © 2001-2019 Matronics. All Rights Reserved.