KitLog pro

Powered By Kitlog Pro v2.0

Scott's Aircraft Build Logs
' style=
Date:  7-21-2014
Number of Hours:  1.00
Manual Reference:  
Brief Description:  Wire runs

I finalized (I hope) the wiring runs fore and aft in the aircaft. In image one:

1. Yellow arrow points the pass-through for strobe cables to the strobe power supply in photo
2. Red arrow - all electrical (trim, baggage compartment light, aft posiition light and anything else electrical) runs through the conduit next to the elevator push tube to the front of the aircraft.)
3. Blue arrow is for Dynon Skyview (network cable, GPS antenna data)

In image two

1. The yellow arrows show the strobe cable run from the left wing across aircraft to the right edge, joining the cable from the right wiing aft.
2. Red arrow is electrical that runs through center section and on the right side of forward center floor
3. Blue arrow is the Dynon Skyview lines that run through the center section and on the left side of the foward center floor.
4. The orange arrows show the antenna cable runs from under the seat pans forward to the left and right side of the forward floor.
' style=

Aft cabin

Aft cabin

' style=

Under seat pans

Under seat pans

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.