Brief Description: Short ribs, tip ribs and stiffener angles
Huge session in the workshop today.
I built the 2 short ribs (behind fuel tank, then rough cut the form block for the tip ribs. DIdn't want to commit to building the tip ribs until I established I was doing the right thing, so while I wait for responses to my questions I started on the attach angles.
I created a lot of useless ribs in the early stages, so there is a lot of scrap. It is VERY time consuming to rescue these, but too much to waste. So I have been using the router along the table edge to cut attach angles and rib attach angles. My brain is a bit fried, so haven't done a final tally for the day.
Although I made good progress, there i s a lot more angles to cut. Then bend, drill and debur. This isn't the most fun part so far!
Aluminium clamped to table edge
the result of rescuing many ruined ribs
My tally sheet. Too many incomplete for my liking!