I went to the hangar this evening with the intent of wiring my Gemini PFD. I had the wiring diagram, so what could go wrong? Since I don't have the unit yet, I had to depend on the preliminary manual for the ADI. Unfortunately, no where in the manual does it state whether or not the connector is male or female. I'll have to check Trutrak's website to see if I can determine that from the photo of the prototype.
I decided to start work on the magnetometer mount. I leveled the angle piece and drilled four holes through the bulkhead. The remaining aluminum parts are due tomorrow, so I'll finish the shelf over the weekend.