KitLog pro

Powered By Kitlog Pro v2.0

Marlins Web Site
' style=
Date:  5-16-2009
Number of Hours:  6.00
Manual Reference:  Sect 8; DWG 27A
Brief Description:  Fabricate Elevator Stops

The elevator bellcrank welds were not the same on the right and left side. When I placed the elevators in their neutral position there was a difference of about 1/8 to 3/16 of an inch. To fabricate the elevator stop I had to grind the difference from one side to the other so the entire bellcrank assembly would contact the stop. I also re-painted the belcrank and welds with appliance enamel...bad idea. The paint peeled and made a mess. I'll clean this up later and reapply a better paint.
' style=

Diagram of elevator stop

Diagram of elevator stop

' style=

Elevator stop installed

Elevator stop installed

' style=

Bellcrank offset on elevator stop

Bellcrank offset on elevator stop

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.