Mark Zilm - Experimental Aircraft Builder's Log

Mark's Helicycle Build


Date: 6-8-2017
Number of Hours: 3.00
Manual Reference:
Brief Description: Transmission Alignment

A 3D printed jig was made for the transmision housing and the hole at the tail rotor so that a fishline could be installed for alignment of the transmission accounting for the 1/4" offset needed due to 400 FT/LBS torque in the transmission.

Fore 3D printed jig

⁮Aft 3D printed jig

Alignment of the transmission

< Previous Log Entry Next Log Entry >