No pictures. I don't like to document my gaffes so publically. Getting back in the shop today was great, but I'm deliberately making little trips with my materials and moving a little slower than usual. With Joy's help, I cut up a 4x8 sheet of MDF into the sizes needed for three sets of form blocks. Then I plotted out and cut the aft bulkhead form blocks. After all the chamfering and finishing, I outlined and cut my .025" aluminum form blank. Without even looking at the plans I bent all the flanges in the same direction, and -- you guessed it -- the bottom flange goes in the opposite direction. Soooo, I've made my goof for the month. No more steam to make another tonight, so that will have to wait till tomorrow after church. Signing off....sigh.