Finished off the left (pilot) side of the cockpit wiring pass through today. This involved fabricating two more wiring brackets - one each for the left seat back side angle and rear wing upright. Once the two brackets were complete, I disassembled all 4 brackets and cleaned them up. I then enclosed the wire bundle with flame-resistant, braided expandable wrap before reassembling all 4 brackets back into position. Lastly, I checked the fit for those brackets with nut plates to make sure the interior side panel fit appropriately.
Completed brackets and wrapped wire bundle - visible on the left as it routes under canopy latch.
Interior side panel temporarily installed using new brackets.