KitLog pro

Powered By Kitlog Pro v2.0

Kupe's Zodiac 650B
' style=
Date:  3-15-2014
Number of Hours:  2.00
Manual Reference:  6-B-15
Brief Description:  Install Front Seat Panel

Measured, trimmed, and set rivet lines for the two forward seat panels. There were 3 rivet lines each: One attaching to the wing Center Spar, one line attaching to the Gear Channel, and one attached to the side skin. Once I drilled them out at pilot hole size, I updrilled all lines to final rivet size to regather the clecoes.

I also updrilled the rivet line where the rear fuselage bottom skin, gear channel, and seat back all share the same rivet line. You can see this rivet line in images 1 and 2 - the line just aft (to the left) of the forward seat panels.
' style=

Forward seat panels attached to Center Spar, Gear Channel, and skin

Forward seat panels attached to Center Spar, Gear Channel, and skin

' style=

Looking forward.  The gap between the seats will contain the armrest.

Looking forward. The gap between the seats will contain the armrest.

' style=

From the outside - a new rivet line on each side skin next to the yellow line I added to the pic.

From the outside - a new rivet line on each side skin next to the yellow line I added to the pic.

' style=










Copyright © 2001-2020 Matronics. All Rights Reserved.