KitLog pro

Powered By Kitlog Pro v2.0

Jim's Web Site
' style=
Date:  7-24-2016
Number of Hours:  8.00
Manual Reference:  
Brief Description:  

I have finally, I think, figured out how to construct the rear seat bottom support flange. Better manual would have helped. The slow build manual would create a situation where the seat bottom would be under the side panels, thus requiring removal of the side panels to get to the flap motor, etc. The fast build manual was not a lot clearer, especially in the steps. What I have now, although not complete, is about a one inch flange, eight bid in total, which will allow removal of the seat bottom without removing the yet to be built side panels. Thanks to those who have wrestled with the same problem, and were kind enough to post pictures of their design.
' style=





' style=




' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.