KitLog pro

Powered By Kitlog Pro v2.0

Building Integrity
' style=
Date:  2-11-2015
Number of Hours:  0.50
Manual Reference:  Section 2
Brief Description:  Oil Cooler removal

My poor attempts to cool my oil is just pathetic. I can't believe how much air this thing needs. DANG. Anyway, before I change locations, I'm going to make a LARGE mouth Plenum that will take in air using an inlet size about 1.5x6 according to some good advise and help I've been given By Donald Berlin who is seeing 170 temps using a 6x2" inlet under his left lower cowling. A great place for a cooler install no doubt. If this next design doesn't work, then I'll be copying his directly and calling it a day. I just see so much drag in using a scoop that size and I'm still thinking that my exit air is being choked by the prop. Spring is coming in a few months and I need these temps down asap. I can't even fly higher than 4500MSL right now without busting 250 degrees. Terrible!
' style=

here we go again

here we go again

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.