KitLog pro

Powered By Kitlog Pro v2.0

Jims RV-8
< Previous Log Entry          Next Log Entry >
' style=
Date:  3-5-2020
Number of Hours:  0.60
Manual Reference:  
Brief Description:  Adhering the LED light ends/wires

As the manufacturer glue used on the LED lights is not super awesome, there is a tendency for the wires that are currently unsupported to pull on the LED lights that are hanging upside-down and is causing them to pull away from the aluminum skin. Eventually, the wires will be supported but until then, this needs a fix. To remedy this, I pulled out some surplus sika flex to better adhere the wire bases. I did two of the top wires and left them to dry. On second thought, since sika take a activator, primer and adhesive – it’s a little more than needed for these wire bases. I will go pull the 3M 1300 adhesive out of the refrigerator and let it warm up for the next round of wire base adhesive.
' style=

some adhesive - some a bit hidden

some adhesive - some a bit hidden

' style=

adhesive and additional tie down

adhesive and additional tie down

' style=
< Previous Log Entry          Next Log Entry >










Copyright © 2001-2024 Matronics. All Rights Reserved.