After looking at a few other internet sites I liked the idea of some dart shaped pieces which cover over where the rudder cables exit the fuselage. So with some scrap sheet cut in half I placed a screwdriver in the vice on an angle and formed/beat/hit the sheet with a rubber mallet until I had a nice curved piece which had an opening on one end. These pieces were then cut to a nice shape and I blind riveted them to the fuselage after alodining them. Also refitted the elevator and control column push rods after getting them powder coated white. I torgued and marked the bolts which hold these together. Ends up being a bit of fun (Not) in getting all the washers in place.