Brief Description: Pages 18-06 and back to pagfe 16-02
Members: Daniel Martinez
Support: Franklin Gaxiola
We continued where we left off, step 4 of page 18-06, we match drilled the holes first with a #40 drill bit and then expanding the hole with a #30 drill bit, completing the step with this. We completed half of step 5 (18-06) because we cannot rivet the Mid Nose Skin yet, we first needed our Outboard nose skin. We set this flaperon apart until we get the nose skin we’re missing. We jumped back to page 16-02 to start working on the stall warning, we completed steps 1 and 2 of said page. While we were working on this, Franklin helped us set a doubler on our W-1206-R, something that was reported on the log of 4/19. The doubler was made from the scrap pieces that were trimmed from our main and nose ribs.
