Page 33-02 Installed lap belts. (step 3) Installed step floor cover and fuel shutoff knob. (step 5 - complete) PAGE 33-02 IS COMPLETE
Page 33-03 Attached shoulder harness cables to strap lugs, then attached shoulder harnesses to other end of shoulder harness cables. (steps 1 and 2) Trimmed grommet and installed on tunnel cover. Temporarily installed tunnel cover. The brake lines do not fit well in the tunnel cover cutout so will need to address that before final installation. (steps 6 and 7) PAGE 33-03 IS COMPLETE
Page 33-04 Test fit anti-abrasion strip to mid fuse brace, then marked 3/4" along aft side. Installed anti-abrasion strip on mid-fuse brace. (steps 1 and 2) Positioned seat wedges, seat bottoms (with crotch strap through seat slot), and seat backs. Velcroed seat back to seat angle. Although not called out in the plans, the seats had additional Velcro strips so those where applied as well. (step 4)