|
|
|
|
DAVE'S WEB SITE
|
Date: 6-3-2006
|
Number of Hours: 4.20
|
Manual Reference:
|
Brief Description: Panel Cutouts
|
|
Made cutouts for stereo, EFIS, and radio.
I ended up reorganizing the entire thing kind of last minute. I had intended on putting the radio underneath the EFIS, but I was never really happy with that. I couldn't figure out why, but I think it was the lack of function in a highly functional area. Long story short, I ended up reorganizing the caution and warning lights, and putting the radio at the top of the stack. Basically I stacked the caution and warning lights along with the TCU disconnect on the left half of the top of the panel, and I put the radio on the top right of the center stack. I like the effect quite a bit more than what I had going on previously, and it got rid of the clown face!
Additionally, I marked all the switch and circuit breaker cutouts on the right side of the panel. I had intended on putting the heater and bilge pump breakers on the left side so the passenger could reach them (primarily the heater), but I'm not sure it's going to work with the three round guages I'm going to have to put in. There is room for those two switches on the right side, but I'll hold off on cutting any holes. There are still six breakers that aren't associated with any switches, so they need a home, but there's plenty of room on the right side of the panel. The only 'issue' is whether or not to put them in line with the other switches/breakers, and that will be decided when I decide where to put the heater/bilge pump switches/breakers.
|
|
|
|
|
|
|
|
|
Copyright © 2001-2024 Matronics. All Rights Reserved.
|
