Brief Description: Finish Fabricating Elevator Stiffeners
I went to Home Depot this morning and picked up the PVC and glue to fabricate a Rod End Bearing Tool. I cut and glued the pieces and then realized that I had not aligned the slot in the tool with the handle. The tool functions fine but it would have been nice as it would have provided an easy reference regarding the alignment of the bearing. Realizing that I wasn't fully awake yet I walked away from the project for a few hours. I came back later and finished fabricating the elevator "H" stiffeners. These were the pieces that I had to order from Van's last week as I was missing the E-702H5. $5.60 for the material and $10.31 for shipping (I had a polo shirt in the shipment as well).
