I did not apply the two ply tapes to the fuselage bulkheads during the inital flox bonding. I did not wnat to upset the fuselage alignment while the flox cured. Today I applied tapes to one side of the fwd seat bulkhead, one side of the aft seat bulkhead, and the firewall (which is not shown in the plans). I pre-pregged the two ply tapes on plastic to keep things nice and neat. Even though everthing was already peel plyed or sanded prior to fuselage assembly I went back and sanded again followed by an acetone wipe. I then floated in a very small micro fillet in the corner prior to taping to ease the corners. I then peel plyed the tapes.