Finsihed laying out holes just about the time Geoff Heap called up and said he was coming over for a bit to check out the rivets I did in the center spar. He wound up helping me set up the right wing spar for drilling. While he ran back home to pick up a few tools I cut the two rear spar caps to length. When he got back we started drilling some holes in the main spar then we switched over to looking at the bad rivets in the center spar. We took one out and it was pretty close to what I was doing to take out some bad rivets previously. He had some good tips though and a few tools I didn't have for the job. He let me borrow a few of his tools and I spent the rest of the day removing bad rivets from the center spar.
