Set about today to finish the spar preparation. Started with the rear spar and cleco'd then riveted the reinforcement fork, and the three spar doublers to the rear spars. Photo #1 shows the reinforcement fork and first doubler plate cleco'd in place. Photo #2 shows the center doubler plate with the cutout for the aileron pushrod riveted in place (the tape is there to block those holes that are not to be riveted yet - they get riveted later with ribs, aileron gap seals and flap braces). Photo #3 shows both rear spars completed and ready to go.
Reinforcement fork and doubler plate cleco'd and in process of being riveted