I removed all the protective paper, plastic and tape from the fuselage. Was happy there were no openings that allowed overspray into the cabin. Next I mixed up 4 grams of the white PTI high build primer. After a 30 minute induction time, I used a Q tip and a plastic razor blade to fill the remaining few pin holes that showed up in the primer coat. All this will be sanded off after I complete my phase fly off, but by temporally filling them now preventing oils/fuels emitted by the engine during break-in. Once done, I cleaned up the shop and moved the fuselage to the center bay. This will give me better access to the paint booth I built in the outside bay, while protecting the fuselage from overspray when I paint the doors and remaining interior pieces.