Powered By Kitlog Pro v2.0
Home of the Spodplane
COZY MK IV
All
11-16-2017
< Previous Log Entry
Next Log Entry >
Date:
11-16-2017
Number of Hours:
3.30
Manual Reference:
14-08/09
Brief Description:
Wing CS Spar outer layups
Trimmed layup, cleaned up some blobs.
Cut flox corners on ends that won't flow over from AFT face with Dremel.
Prepped sites for LWA2/3 and floxed in place secured with trigger clamps, adding a block over LWA3.
Pre-filled edges with excess flox.
After a few hours break the flox was setting up nicely so finished floxing the edges of LWA2/3 and layed up 3 x UND strips over each hardpoint.
Floxed up the ends, prepped foam and 1 x BID over the aft face of the hardpoints, overlapping onto the ends
Cutting out inspection holes
Trimming transition
Outer hardpoints in place
< Previous Log Entry
Next Log Entry >
SITE NAVIGATION
Contact Builder
COZY MK IV Home
Category
# Logs
# Hours
All
1515
3379
Casa del Spodd
4
2
CH03 - Repair
2
5
CH04 - Fus Bulkheads
36
64
CH05 - Fus sides
17
53
CH06 - Fus Assembly
36
85
CH07 - Fus Exterior
31
58
CH08 - Fus Innards
26
52
CH09 - MLG
96
217
CH10 - Canard
56
115
CH11 - Elevators
38
58
CH12 - Fit Canard
12
19
CH13 - Nose
134
229
CH14 - Center Spar
53
117
CH15 - Firewall
12
38
CH16 - Controls
52
76
CH17 - Air Brake
6
8
CH18 - Canopy
117
299
CH19 - Wings
176
407
CH20 - Winglets
94
179
CH21 - Strakes
144
369
CH22 - Electrical
1
1
CH23 - Engine & Cowl
83
225
CH24 - Seats, Armres
132
228
CH25 - Finishing
137
452
Materials
6
4
Miscellaneous
2
5
Shop Supplies
2
8
TC reports
10
6
Copyright © 2001-2024 Matronics. All Rights Reserved.