KitLog pro

Powered By Kitlog Pro v2.0

Home of the Spodplane
' style=
Date:  1-26-2015
Number of Hours:  1.30
Manual Reference:  
Brief Description:  MLG Attach Tab trimming

Took one look at LB Fus cutout and despaired. Lots of air under the layup, lots of excess resin around where the plastic touched it. Horrible. Inner surface of LB is OK. I put it in the cutout, and will confront when the MLG Strut is complete.

Trimmed MLG Attach Tabs. Top layer is a bit dry in the corners, had some resin leaching into the clamping boards. Drilling through the pilot holes delaminated the not fully cured inner tabs. Delam area is smaller than the eventual holes, but all a bit disheartening. Got a bit pissed last night, and regrets are everywhere...

Placed strut in fuselage for trial fit. Not successful, Despite jigs pilot holes are not square to face of tabs, total error about 1/4", and not sure where the error lies. All in all a shit day. :(
' style=

Trimming tabs

Trimming tabs

' style=

Trimming LB

Trimming LB

' style=

Placing LB over Fus cutout layup mess. Couldn't bear to take a picture of it yet, don't want to see it

Placing LB over Fus cutout layup mess. Couldn't bear to take a picture of it yet, don't want to see it

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.