KitLog pro

Powered By Kitlog Pro v2.0

Bobs Ten
' style=
Date:  9-15-2014
Number of Hours:  1.50
Manual Reference:  
Brief Description:  Install Overhead Vent Flanges

1830 - 2000

Location of flanges was based on VAF recommendations. Thanks Ed, Bob, et al...

Flanges wer trimmed to provide clearance for previously installed nut plates.

Smooth all edges of flanges using s/b wheel.

Locate flanges and match drill fuselage bulkhead, cleco as drilled.

Mark interior of flange duct on bulkhead.

Remove clecos.

Debur holes.

Remove duct section of bulkhead using hole saw.

Debur and smooth edges of bulkhead using debur tool and s/b wheel.

Dimple bulkhead for flush rivets.

Dimple dust flange for flush rivets.

Temporarily install flanges, verify fit.

These flanges will be riveted AFTER forward fuselage skin is riveted in place. This will allow easier access to buck the skin rivets.
' style=





' style=




' style=




' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.