KitLog pro

Powered By Kitlog Pro v2.0

Bobs Ten
< Previous Log Entry          Next Log Entry >
' style=
Date:  5-3-2013
Number of Hours:  2.80
Manual Reference:  QB Wings
Brief Description:  Install Fuel Senders, Aux Tank Bungs

1312 - 1600

Visually inspect inside of fuel tank from sender unit hole.

Using a short wrench, verified that vent line fitting were tight.

Clean sending unit hole area with s/b.

Using acetone, cleaned this area until rag came back clean.

Clean sending unit base.

Clean aux tank fitting area with s/b.

Using acetone, cleaned this area until rag came back clean.

Clean tank bung using s/b and acetone.

Mix single use Proseal per directions.

Apply proseal to fuel tank rib around sending unit hole.

Apply proseal tosending unit base.

Install sending unit using AN515-8R18 screws. Prior to installing screws, rolled threads in proseal.

Tighten screws evenly, create fillet between rib and sending unit. Proseal over screw heads..

Repeat for other side.

Apply proseal to aux tank bung and fuel tank rib.

Cleco bung to rib.

Rivet bung to rib using included closed end rivets, 6x.

Create fillet around bung and over rivet heads.
' style=





' style=




' style=




' style=
< Previous Log Entry          Next Log Entry >










Copyright © 2001-2024 Matronics. All Rights Reserved.