KitLog pro

Powered By Kitlog Pro v2.0

Bobs Ten
' style=
Date:  4-14-2020
Number of Hours:  1.60
Manual Reference:  
Brief Description:  Install Mounts for Vent Tubing

1530 - 1706

I fabricated a U shaped mount to support the fresh air vent ducting in the tailcone.

I used 1" square 6061 tubing to fabricate the mounts. One side of the tubing was removed using the bandsaw. Holes were drilled for blind rivets.

The mount was deburred, shaped and smoothed.

Next, the mount s located and clamped into position. The bulkhead was match drilled.

All holes were deburred.

A large tie wrap mount was installed on the mount using adhesive tape.

The mount was clecoed in place and riveted using aluminum rivets.

The process was repeated for the opposite side.
' style=





' style=




' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.