KitLog pro

Powered By Kitlog Pro v2.0

Bobs Ten
' style=
Date:  7-23-2016
Number of Hours:  3.20
Manual Reference:  
Brief Description:  Install Rudder Trim

1600 - 1836 2000 - 2036

Install rudder trim.

Temporarily install vertical stab and rudder.

Connect rudder cables to rudder horn.

Clamp rudder in trail position.

I noticed that when in trail position, the pilot side rudder pedals were not centered. I fabricated another set of cable links to rectify this issue. Small issue but could be annoying later. New links were fabricated from 050 high strength SS as before.

Connect rudder cable to new link.

Locate and mark top center on rudder torque tubes for placement of the rudder trim arms.

Verify arm location fit and check for interference. Location looks good, approximately same location as in photos on aerosportproducts.com.
' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.