Cut, intial fitting and drilling and clecoing the two Stablator Tips. After thinking for several day on how I could cut the stabilator tips I came up with a makeshift tool to hold upright an air powered cutoff tool. Something likened to a lateral table saw (see pictures). I had discussed with others how to use a ban saw or a router but felt these would be difficult to hold a straight edge on these parts.
Bob an I worked 3 hours each to set up a complete this task. I am very pleased with the results.
An enprivized tool using an air powered cut off saw
An enprivized tool using an air powered cut off saw
An enprivized tool using an air powered cut off saw