KitLog pro

Powered By Kitlog Pro v2.0

Chris' Web Site
' style=
Date:  9-18-2019
Number of Hours:  4.00
Manual Reference:  
Brief Description:  Lower Wing

Plans:
1. Adjust seat back.
Status: Complete. I decided to tilt the seat backwards slightly more. I am predicting it needed to be reclined a tad more to be comfortable.
2. Add the remaining leading edge reinforcement to the lower wing.
Status: 40% complete. Several tasks needed to happen before I could finish the leading edge. First, I need to remove the N strut to make the area accessible. Second, I need to cut out passage areas for the N struts in the aluminum sheets. Third, I need to fabricate the trim covers for the passages. Fourth, I need to add plate nuts to the sheeting for securing the trim covers. Steps one to three were completed today for the right wing.
' style=

Temporary Scaffold to Replace the

Temporary Scaffold to Replace the "N" Struts

' style=

Leading Edge Trim Plate

Leading Edge Trim Plate

' style=

Rear View from Right Side

Rear View from Right Side

' style=










Copyright © 2001-2024 Matronics. All Rights Reserved.