KitLog pro

Powered By Kitlog Pro v2.0

Wesleys Web Site
Work Logs Found: 28
Category Work Time: 70 Hours
 Date
Hours
Work Log Summary

Details

 10-18-2021
1.50
Strip and crimp Communication radio antenna coax c
Details

 10-17-2021
1.50
ADAHARS and Magnometer installation
Details

 10-14-2021
1.50


 10-12-2021
1.50
Pulled coax cable to GPS and Com radio antenna
Details

 10-07-2021
2.00
Relocate the flap switch
Details
     

 10-06-2021
1.00
Flap switch mounting and linkage for flap position

 10-04-2021
2.00
Pulled main electrical run from EFIS to forward fi
Details
       

 10-02-2021
9.00
Cabin lighting, wire protection, and clean up
Details
       

 10-01-2021
1.50
signal line from grip to bagage compartment
Details

 09-30-2021
1.00
Pinned and wired both localized ground lines for g

 09-28-2021
1.50
Wiring in cockpit lighting
Details

 09-27-2021
2.00
Secure wire runs from pilot and co-pilot stick swi
Details
       

 09-26-2021
2.00
Pinned the front grip switches for hat switch trim

 09-22-2021
1.75
Wiring on Front seat heat.
Details

 09-21-2021
2.00
Wiring for seat heat
Details
       

 09-20-2021
1.50
Work on securing the wiring on the flap motor and
     

 09-19-2021
2.50
connectors for flap motor and position sensor
Details
       

 09-18-2021
3.00
Pinning connector for roll trim system and securin
Details
     

 09-18-2021
2.50
Fabricated the flap position sensor mount and conn
Details
     

 09-17-2021
1.75
pulling and securing wires

 09-14-2021
3.00
Work on wiring and wire rash protection covers

 08-20-2021
3.00
Worked on wiring for seat heat switches
Details
     

 08-14-2021
6.50
working on wiring and rubber grommets through fuse
Details
     

 06-11-2021
4.00
Finished up the left Landing/taxi light lense
Details
       

 06-09-2021
1.50
Cut, sand, and fit the left landing / taxi light l
Details
     

 06-08-2021
1.00
Cutting and fitting the lenses for the wing tips
Details
     

 06-05-2021
4.00
Fitting and mounting the landing, taxi Aero LED VX
Details
       

 06-04-2021
4.00
Drill and cut out paterns for Aero LED VX landing
Details
     










Copyright © 2001-2024 Matronics. All Rights Reserved.